NZS/AS 1830:1986 Iron castings - Grey cast iron

Abbreviation
NZS/AS 1830:1986
Valid from
3/02/1986

Information provider
Standards New Zealand,
Author
Standards New Zealand, Standards Australia
Information type
New Zealand Standard,
Format
HARD COPY,


Description

This Standard specifies requirements for flake graphite grey iron castings produced in sand or ceramic moulds, supplied to tensile strength requirements when intended for general engineering purposes and for applications where hardness, microstructure and machinability are the prime requirements.

Scope

This standard specifies requirements for flake graphite grey iron castings, produced in sand or ceramic moulds, as follows:

  • T-series - seven grades of castings for general engineering, primarily to tensile strength requirements (see Section 2).
  • H-series - four grades of castings for applications where hardness, microstructure and machinability are the prime requirements, e.g. the automotive and appliance industries (see Section 3).


NOTES:

  1. Typical properties of flake graphite grey cast iron are given in Appendix C.
  2. Guidelines to purchasers on requirements that must be specified by the purchaser and those that must be agreed at the time of enquiry and/or order are given in Appendix A.
For assistance with locating previous versions, please contact the information provider.
Notes/comments

This Standard is not available online from Standards New Zealand, the link refers users to AS 1830-1986 as the joint equivalent Standard.

View on Information Provider website
For assistance with locating previous versions, please contact the information provider.

This Standard is not available online from Standards New Zealand, the link refers users to AS 1830-1986 as the joint equivalent Standard.

This resource is cited by:

NZS/AS 1830:1986 Iron castings - Grey cast iron

This document is CITED BY:

NZS/AS 1830:1986 Iron castings - Grey cast iron

Description

This Standard specifies requirements for flake graphite grey iron castings produced in sand or ceramic moulds, supplied to tensile strength requirements when intended for general engineering purposes and for applications where hardness, microstructure and machinability are the prime requirements.

View on Information Provider website
NZS/AS 1830:1986 Iron castings - Grey cast iron
Description

This Standard specifies requirements for flake graphite grey iron castings produced in sand or ceramic moulds, supplied to tensile strength requirements when intended for general engineering purposes and for applications where hardness, microstructure and machinability are the prime requirements.

View on Information Provider website
This resource does not cite any other resources.

NZS/AS 1830:1986 Iron castings - Grey cast iron

This resource does not CITE any other resources.
Feedback