Save

ISO 898-1:1999 Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs

Abbreviation
ISO 898-1:1999
Valid from
26/08/1999

Information provider
Standards New Zealand
Author
International Organization for Standardization
Information type
ISO Standard
Format
PDF


Description

This part of ISO 898 specifies the mechanical properties of bolts, screws and studs when tested at room temperature (see ISO 1).

Properties will vary at higher and lower temperature.

 

Scope

This part of ISO 898 applies to bolts, screws and studs -

  • with nominal thread diameter [d  39 mm] (coarse and fine pitch);
  • with triangular ISO thread according to ISO 68;
  • with diameter/pitch combinations according to ISO 261 and ISO 262;
  • with thread tolerance according to ISO 965-1 and ISO 965-2;
  • of any shape;
  • made of carbon steel or alloy steel.

It does not apply to set screws and similar threaded fasteners (see ISO 898-5).

It does not specify requirements for such properties as -

  • weldability;
  • corrosion-resistance (see ISO 3506);
  • ability to whistand temperatures above +300 C or below -50 C.
For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 898-1:1999 Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs

This document is CITED BY:

ISO 898-1:1999 Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs

Description

This part of ISO 898 specifies the mechanical properties of bolts, screws and studs when tested at room temperature (see ISO 1).

Properties will vary at higher and lower temperature.

 

View on Information Provider website
ISO 898-1:1999 Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs
Description

This part of ISO 898 specifies the mechanical properties of bolts, screws and studs when tested at room temperature (see ISO 1).

Properties will vary at higher and lower temperature.

 

View on Information Provider website
This resource does not cite any other resources.

ISO 898-1:1999 Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs

This resource does not CITE any other resources.
Save
Feedback