Skip to main content Skip to primary navigation
Resource detail
Citations

ISO 13953:2001 Polyethylene (PE) pipes and fittings - Determination of the tensile strength and failure mode of test pieces from a butt-fused joint

View on Information Provider website
Abbreviation
ISO 13953:2001
Valid from
25/10/2001
Information provider
Standards New Zealand,
Author
International Organization for Standardization
Information type
ISO Standard,
Format
PDF, HARD COPY,
Cited By
This resource is cited by 2 documents (show Citations)
Description

This International Standard describes a test method for determination of the tensile strength and tensile failure mode of butt-fused polyethylene (PE) pipe assemblies. The method is applicable to butt-fused joints between PE pipes with a nominal outside diameter of not less than 90 mm. The method may be used, together with other test methods, to evaluate the quality of the butt-fused joints.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 13953:2001 Polyethylene (PE) pipes and fittings - Determination of the tensile strength and failure mode of test pieces from a butt-fused joint

This document is CITED BY:

ISO 13953:2001 Polyethylene (PE) pipes and fittings - Determination of the tensile strength and failure mode of test pieces from a butt-fused joint

Description

This International Standard describes a test method for determination of the tensile strength and tensile failure mode of butt-fused polyethylene (PE) pipe assemblies. The method is applicable to butt-fused joints between PE pipes with a nominal outside diameter of not less than 90 mm. The method may be used, together with other test methods, to evaluate the quality of the butt-fused joints.

View on Information Provider website
ISO 13953:2001 Polyethylene (PE) pipes and fittings - Determination of the tensile strength and failure mode of test pieces from a butt-fused joint
Description

This International Standard describes a test method for determination of the tensile strength and tensile failure mode of butt-fused polyethylene (PE) pipe assemblies. The method is applicable to butt-fused joints between PE pipes with a nominal outside diameter of not less than 90 mm. The method may be used, together with other test methods, to evaluate the quality of the butt-fused joints.

View on Information Provider website
This resource does not cite any other resources.

ISO 13953:2001 Polyethylene (PE) pipes and fittings - Determination of the tensile strength and failure mode of test pieces from a butt-fused joint

This resource does not CITE any other resources.
Feedback