Save

BS EN ISO 10684:2004 Fasteners. Hot dip galvanized coatings

Abbreviation
BS EN ISO 10684:2004
Valid from
01/07/2004

Information provider
Standards New Zealand
Author
International Standardization Organisations
Information type
ISO Standard
Format
PDF


Description

ISO 10684:2004 specifies material, process, dimensional and some performance requirements for hot dip spun galvanized coatings applied to coarse threaded steel fasteners from M8 up to and including M64 and for property classes up to and including 10.9 for bolts, screws and studs and 12 for nuts.

It is not recommended to hot dip galvanize threaded fasteners in diameters smaller than M8 and/or with pitches below 1,25 mm.

 

Scope

ISO 10684:2004 primarily concerns the spun hot dip galvanizing of threaded steel fasteners, but it may also be applied to other threaded steel parts.

The specifications given in this document may also be applied to non-threaded steel parts such as washers.

 

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

BS EN ISO 10684:2004 Fasteners. Hot dip galvanized coatings

This document is CITED BY:

BS EN ISO 10684:2004 Fasteners. Hot dip galvanized coatings

Description

ISO 10684:2004 specifies material, process, dimensional and some performance requirements for hot dip spun galvanized coatings applied to coarse threaded steel fasteners from M8 up to and including M64 and for property classes up to and including 10.9 for bolts, screws and studs and 12 for nuts.

It is not recommended to hot dip galvanize threaded fasteners in diameters smaller than M8 and/or with pitches below 1,25 mm.

 

View on Information Provider website
BS EN ISO 10684:2004 Fasteners. Hot dip galvanized coatings
Description

ISO 10684:2004 specifies material, process, dimensional and some performance requirements for hot dip spun galvanized coatings applied to coarse threaded steel fasteners from M8 up to and including M64 and for property classes up to and including 10.9 for bolts, screws and studs and 12 for nuts.

It is not recommended to hot dip galvanize threaded fasteners in diameters smaller than M8 and/or with pitches below 1,25 mm.

 

View on Information Provider website
This resource does not cite any other resources.

BS EN ISO 10684:2004 Fasteners. Hot dip galvanized coatings

This resource does not CITE any other resources.
Save
Feedback