Save

ASTM E384 - 99 Standard Test Method for Microindentation Hardness of Materials

Abbreviation
ASTM E384 - 99
Valid from
01/01/1999

Information provider
American Society of Testing and Materials
Information type
ASTM Standard
Format
PDF

Description

 

Testing the hardness of materials by micro indentation methods

Scope

1.1 This test method covers determination of the microindentation hardness of materials, the verification of microindentation hardness testing machines, and the calibration of standardized test blocks.

1.2 This test method covers microindentation tests made with Knoop and Vickers indenters under test forces in the range from 1 to 1000 gf (9.8 10-3 to 9.8 N).

1.3 This test method includes an analysis of the possible sources of errors that can occur during microindentation testing and how these factors affect the accuracy, repeatability, and reproducibility of test results.

Note 1—While Committee E04 is primarily concerned with metals, the test procedures described are applicable to other materials.

 

 

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is not cited by any other resources.

ASTM E384 - 99 Standard Test Method for Microindentation Hardness of Materials

This document is not CITED BY any other resources:

ASTM E384 - 99 Standard Test Method for Microindentation Hardness of Materials

Description

 

Testing the hardness of materials by micro indentation methods

View on Information Provider website
ASTM E384 - 99 Standard Test Method for Microindentation Hardness of Materials
Description

 

Testing the hardness of materials by micro indentation methods

View on Information Provider website
This resource does not cite any other resources.

ASTM E384 - 99 Standard Test Method for Microindentation Hardness of Materials

This resource does not CITE any other resources.
Save
Feedback