Save

AS 681.1-2008 Elastomeric seals - Material requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber

Abbreviation
AS 681.1-2008
Valid from
05/02/2008

Information provider
SAI Global
Author
Standards Australia
Information type
Australian Standard
Format
PDF


Description

This Standard specifies requirements for materials used in vulcanized rubber seals for cold potable water supply (up to 50°C), hot potable and non-potable water supply (up to 110°C), and drainage, sewerage and rainwater systems (continuous flow up to 45°C and intermittent flow up to 95°C).

Scope

This Standard specifies requirements for materials used in vulcanized rubber seals for:

  1. cold potable water supply (up to 50°C);
  2. hot potable and non-potable water supply (up to 110°C);
  3. drainage, sewerage and rainwater systems (continuous flow up to 45°C and intermittent flow up to 95°C).

The different designations of seals specified are defined according to their type, application and requirements (see Table 4).

General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design. This standard should be used where appropriate with product standards which specify performance requirements for joints.

This standard is applicable to joint seals for all pipeline materials, including iron, steel, clay, fibre cement, concrete, reinforced concrete, plastic and glass-reinforced plastics.

It is applicable to elastomeric components of composite or non-composite seals. In the case of composite seals for materials of hardness ranges from 76 IRHD to 95 IRHD the reuirements for elongation at break, compression set and stress relaxation apply only when the material is participating in the sealant function, or the long term stability of the seal.

Joint seals made with an enclosed void as part of their design are included in the scope of this Eurepean Standard.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 681.1-2008 Elastomeric seals - Material requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber

This document is CITED BY:

AS 681.1-2008 Elastomeric seals - Material requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber

Description

This Standard specifies requirements for materials used in vulcanized rubber seals for cold potable water supply (up to 50°C), hot potable and non-potable water supply (up to 110°C), and drainage, sewerage and rainwater systems (continuous flow up to 45°C and intermittent flow up to 95°C).

View on Information Provider website
AS 681.1-2008 Elastomeric seals - Material requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber
Description

This Standard specifies requirements for materials used in vulcanized rubber seals for cold potable water supply (up to 50°C), hot potable and non-potable water supply (up to 110°C), and drainage, sewerage and rainwater systems (continuous flow up to 45°C and intermittent flow up to 95°C).

View on Information Provider website
This resource does not cite any other resources.

AS 681.1-2008 Elastomeric seals - Material requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber

This resource does not CITE any other resources.
Save
Feedback