AS 4100-1990 Steel structures

Abbreviation
AS 4100-1990
Amendment
AS 4100-1990/Amdt 1-1992 AS 4100-1990/Amdt 2-1993 AS 4100-1990/Amdt 3-1995
Valid from
26/10/1990

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This Standard sets out minimum requirements for the design, fabrication, erection, and modification of steelwork in structures in accordance with the limit states design method.

It incorporates AS 1511, SAA High-strength Structural Bolting Code.

Scope

This Standard applies to buildings, structures and cranes constructed of steel.

This Standard is intended to apply also to roadway, railway, and pedestrian bridges. However, the requirements given in this Standard may not always be sufficient for bridge applications. In these circumstances, the specifications of the relevant Authority shall be used.

This Standard does not apply to the following structures and materials:

  • Steel elements less than 3 mm thick, with the exception of sections complying with AS 1163 and packers.
  • Steel members for which the value of the yield stress used in design (fy) exceeds 450 MPa.
  • Coldformed members, other than those complying with AS 1163, which shall be designed in accordance with AS 1538.
  • Composite steelconcrete members, which shall be designed in accordance with AS 2327.

NOTE: The general principles of design, fabrication, erection, and modification embodied in this Standard may be applied to steelframed structures or members not specifically mentioned herein.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 4100-1990 Steel structures

This document is CITED BY:

AS 4100-1990 Steel structures

Description

This Standard sets out minimum requirements for the design, fabrication, erection, and modification of steelwork in structures in accordance with the limit states design method.

It incorporates AS 1511, SAA High-strength Structural Bolting Code.

View on Information Provider website
AS 4100-1990 Steel structures
Description

This Standard sets out minimum requirements for the design, fabrication, erection, and modification of steelwork in structures in accordance with the limit states design method.

It incorporates AS 1511, SAA High-strength Structural Bolting Code.

View on Information Provider website
This resource does not cite any other resources.

AS 4100-1990 Steel structures

This resource does not CITE any other resources.
Feedback