AS 2887-1993 (R2017) Plastic waste fittings

Abbreviation
AS 2887-1993
Valid from
15/11/1993

Information provider
Intertek Inform
Author
Standards Australia
Information type
Australian Standard
Format
PDF, HARD COPY


Description

This Standard specifies requirements for moulded or fabricated plastic waste fittings for use in plumbing installations. Such fittings are suitable for receiving short-duration, intermittent liquid discharges at temperatures not exceeding 95C. 

Scope

NOTE:

Where it is envisaged that a plastic waste fitting will be used in an environment where temperatures in excess of 95C are common, advice should be sought from the manufacturer.

UPVC fittings for soil, waste and vent applications are not covered by this Standard (see AS 1415).

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 2887-1993 (R2017) Plastic waste fittings

This document is CITED BY:

AS 2887-1993 (R2017) Plastic waste fittings

Description

This Standard specifies requirements for moulded or fabricated plastic waste fittings for use in plumbing installations. Such fittings are suitable for receiving short-duration, intermittent liquid discharges at temperatures not exceeding 95C. 

View on Information Provider website
AS 2887-1993 (R2017) Plastic waste fittings
Description

This Standard specifies requirements for moulded or fabricated plastic waste fittings for use in plumbing installations. Such fittings are suitable for receiving short-duration, intermittent liquid discharges at temperatures not exceeding 95C. 

View on Information Provider website
This resource cites:

AS 2887-1993 (R2017) Plastic waste fittings

This document CITES:
New Zealand Standards
Australian Standards
Feedback