Save

AS 1733-1976 (R2018) Methods for the determination of grain size in metals

Abbreviation
AS 1733-1976
Valid from
01/05/1976

Information provider
SAI Global
Author
Standards Australia
Information type
Australian Standard
Format
PDF, hard copy


Description

This standard describes methods for the determination of the grain size in metals and alloys.

Scope

In separate sections this Standard covers general procedures for determining grain size in metals and alloys by estimation of grain size using the comparison method and by calculation of grain size number using the intercept and planimetric methods, specific procedures for austenitic grain size in steels by a range of micrographic methods, and specific procedures for metals and alloys consisting principally of a single phase.

Appendices provide explanatory notes on specifying austenitic grain size limits for steel, list etching reagents, and show the standard grain size charts for untwinned grains (flat etch), twinned grain (flat etch), and heavily twinned grains (contrast etch).

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1733-1976 (R2018) Methods for the determination of grain size in metals

This document is CITED BY:

AS 1733-1976 (R2018) Methods for the determination of grain size in metals

Description

This standard describes methods for the determination of the grain size in metals and alloys.

View on Information Provider website
AS 1733-1976 (R2018) Methods for the determination of grain size in metals
Description

This standard describes methods for the determination of the grain size in metals and alloys.

View on Information Provider website
This resource does not cite any other resources.

AS 1733-1976 (R2018) Methods for the determination of grain size in metals

This resource does not CITE any other resources.
Save
Feedback