Save

AS/NZS 5033:2014 Installation and safety requirements for photovoltaic (PV) arrays

Abbreviation
AS/NZS 5033:2014
Amendment
Amendments: 1 - incorporated, 2 - appended.
Valid from
06/11/2014

Information provider
Standards New Zealand
Author
Standards New Zealand, Standards Australia
Information type
New Zealand Standard
Format
PDF

Description

This standard sets out general installation and safety requirements for photovoltaic (PV) arrays, including d.c. array wiring, electrical protection devices, switching and earthing up to but not including energy storage devices or loads.

Provisions relating to power conversion equipment are covered only where d.c. safety issues are involved. Small d.c. conditioning units intended for connection to one or two PV modules are included.

The safety requirements of this standard are critically dependent on the inverters associated with PV arrays complying with the requirements of IEC 62109-1 and IEC 62109-2 and all power conversion equipment complying with IEC 62109 series standards. PV arrays in portable equipment of less than 240 W and less than 50 V open circuit voltage at standard test condition (STC) are not covered by this standard. PV arrays of greater than 240 kW at STC are not covered by this standard.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is not cited by any other resources.

AS/NZS 5033:2014 Installation and safety requirements for photovoltaic (PV) arrays

This document is not CITED BY any other resources:

AS/NZS 5033:2014 Installation and safety requirements for photovoltaic (PV) arrays

Description

This standard sets out general installation and safety requirements for photovoltaic (PV) arrays, including d.c. array wiring, electrical protection devices, switching and earthing up to but not including energy storage devices or loads.

Provisions relating to power conversion equipment are covered only where d.c. safety issues are involved. Small d.c. conditioning units intended for connection to one or two PV modules are included.

The safety requirements of this standard are critically dependent on the inverters associated with PV arrays complying with the requirements of IEC 62109-1 and IEC 62109-2 and all power conversion equipment complying with IEC 62109 series standards. PV arrays in portable equipment of less than 240 W and less than 50 V open circuit voltage at standard test condition (STC) are not covered by this standard. PV arrays of greater than 240 kW at STC are not covered by this standard.

View on Information Provider website
AS/NZS 5033:2014 Installation and safety requirements for photovoltaic (PV) arrays
Description

This standard sets out general installation and safety requirements for photovoltaic (PV) arrays, including d.c. array wiring, electrical protection devices, switching and earthing up to but not including energy storage devices or loads.

Provisions relating to power conversion equipment are covered only where d.c. safety issues are involved. Small d.c. conditioning units intended for connection to one or two PV modules are included.

The safety requirements of this standard are critically dependent on the inverters associated with PV arrays complying with the requirements of IEC 62109-1 and IEC 62109-2 and all power conversion equipment complying with IEC 62109 series standards. PV arrays in portable equipment of less than 240 W and less than 50 V open circuit voltage at standard test condition (STC) are not covered by this standard. PV arrays of greater than 240 kW at STC are not covered by this standard.

View on Information Provider website
This resource does not cite any other resources.

AS/NZS 5033:2014 Installation and safety requirements for photovoltaic (PV) arrays

This resource does not CITE any other resources.
Save
Feedback